Quote:
Originally Posted by Matar
From what I am seeing the wedge mount stems are for 1" and smaller holes while the molded in rod holder ID is over and 1-1/4" and just smaller the an 1-1/2". To me these will not work. What i did was take a Peice of 1-1/4" PVC pipe and add a cap. Mount the ball mount to the cap and cut the pipe to legnth. the pipe will be a little sloppy so a little bit of heavy tape and a tight fit.
|
How did you join the PVC to the cap and the ball mount to the cap? did you use glue, if so what type?
07-08-2011, 12:04 PM
Threaded Mode