mounting transducer

[bus kid]

I did a wet mount thru the rear scupper on a custom bracket on my revo, i will post some pics when i get off the freeway!

[danjor]

Get a flush mount transducer. The look great and on paper should work better.

[bus kid]

here you go.
2013-02-17_12-49-12_368.jpg

2013-02-17_12-42-57_965.jpg

2013-02-17_12-47-17_296.jpg

2013-02-17_12-48-12_112.jpg

2013-02-17_12-49-00_489.jpg

more to follow still downloading to my tablet from the cloud

[bus kid]

last 2
2013-02-17_12-07-27_260.jpg

2013-02-17_12-47-46_965.jpg

It works great,I just have to be mind full of when I slide the hull along the bed extender to load and unload.

[Hunters Pa]

How brave are ya?????

http://www.kayaksportfishing.com/php...pic.php?t=8407

Still dry almost 4 years later.

[TJones]

lowrance actually sells the bracket that you made . the only negative is i need the scupper for hobie tank . so this idea is not what i want . i did do a similar mount with the hummingbird transducer . i used the forward seat drain scupper . if i took a wave on the launch i would not drain out as fast which was not good . thanks for suggestions .

[TJones]

using one of those plastic snap together lunch boxes . cut out bottom section and glue to kayak . mount trans to top of box . put water in box and snap top on . anyone have pictures of this ?

[danjor]

Originally Posted by TJones

lowrance actually sells the bracket that you made . the only negative is i need the scupper for hobie tank . so this idea is not what i want . i did do a similar mount with the hummingbird transducer . i used the forward seat drain scupper . if i took a wave on the launch i would not drain out as fast which was not good . thanks for suggestions .

The humminbird mount I used to have on my trident almost sunk my yak first time launching with it. Didn't let that side of the foot well drain and it all flooded in threw the rod pod. By the time I got past the surf which took longer than normal (probably due to the water flooding in the yak) I only had a couple inches of air in the hull before it would have gone down. Good concept in the mount but bad design since it plugs the scupper....
All is good now though. Have a x factor with a thru hull flush mount transducer

[bus kid]

Originally Posted by TJones

lowrance actually sells the bracket that you made . the only negative is i need the scupper for hobie tank . so this idea is not what i want . i did do a similar mount with the hummingbird transducer . i used the forward seat drain scupper . if i took a wave on the launch i would not drain out as fast which was not good . thanks for suggestions .

I looked at the lowerance but didnt like the plastic rod and the donut in the scupper to keep it aligined.Mine drains 100 times better then the lowerance as I didnt use a "dount" inside the scupper like the lowrance does. The bracket I made has a angle in it that maintains the alignment. I have been using a hobie live well and doing surf launches for about 2 months now no issues with it to date.