need suggestions - Kayak Fishing Adventures on Big Water’s Edge

FlyFishinYakr · 01-18-2013, 06:47 PM

You might also try "Break Free" I learned to use this to clean reels when I worked at a tackle shop. Spritz, let soak for a while an corroded screws would come loose without a problem. I don't see why this wouldn't' work on insulated wires, spray a little on the wires let it run down into the insulation (hang it up by the wires overnight for thorough penetration, spritz a little more the next day and scrub with a toothbrush and it should clean most of the rust off.
FFY

TJones · 01-19-2013, 05:51 AM

Learning experience. I didn't know about electrical grease . Found out the hard way. Fish finder, motor.

01-19-2013, 05:51 AM	#2
TJones Senior Member Join Date: Jan 2012 Posts: 2,526	Thx everyone Learning experience. I didn't know about electrical grease . Found out the hard way. Fish finder, motor.

01-18-2013, 06:47 PM	#1
FlyFishinYakr Senior Member Join Date: Mar 2011 Location: Nor Cal...30 min from Bodega/Tomales Bay, 1hr from Clear Lake, 2+ hr to Berryessa & the Delta Posts: 729	You might also try "Break Free" I learned to use this to clean reels when I worked at a tackle shop. Spritz, let soak for a while an corroded screws would come loose without a problem. I don't see why this wouldn't' work on insulated wires, spray a little on the wires let it run down into the insulation (hang it up by the wires overnight for thorough penetration, spritz a little more the next day and scrub with a toothbrush and it should clean most of the rust off. FFY