transducer mount - Kayak Fishing Adventures on Big Water’s Edge

Fiskadoro · 03-30-2010, 03:16 PM

The wet mount in the hull like DS's is a good place to start. I tried beaming through the hull, but eventfully went a little further..

You can read about how I did it here: http://www.bigwatersedge.com/bwevb/s...ead.php?t=4454

Not for everyone but far superior when it comes to performance.

As to batteries I run two... I'm running a 12v 10ah NIMH battery for electronics, it will power my Garmin 398 all day 12 hours plus with power to spare, and weighs less than a 7.5ah lead acid. It's supposed to take over a 1000 charges. Shows no signs of wearing out after two seasons.

For the bait tanks I'm using a standard lead acid 6v 10ah and it powers the tank all day no problem at a better (lower) flow rate then a 12v. It's definitely the way to go...

Jim

03-30-2010, 03:16 PM	#7
Fiskadoro ....... Join Date: Jan 2009 Posts: 1,509	The wet mount in the hull like DS's is a good place to start. I tried beaming through the hull, but eventfully went a little further.. You can read about how I did it here: http://www.bigwatersedge.com/bwevb/s...ead.php?t=4454 Not for everyone but far superior when it comes to performance. As to batteries I run two... I'm running a 12v 10ah NIMH battery for electronics, it will power my Garmin 398 all day 12 hours plus with power to spare, and weighs less than a 7.5ah lead acid. It's supposed to take over a 1000 charges. Shows no signs of wearing out after two seasons. For the bait tanks I'm using a standard lead acid 6v 10ah and it powers the tank all day no problem at a better (lower) flow rate then a 12v. It's definitely the way to go... Jim Last edited by Fiskadoro; 03-30-2010 at 03:29 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode