Hobie Pedal Drive - Bent Mast - Kayak Fishing Adventures on Big Water’s Edge

JohnMckroidJr · 07-26-2020, 05:25 PM

Try leaving it alone. I have replaced over a dozen bent masts. At one time I would bend them back, but when you bend it back, sometime later you will be peddling along and it will snap. Bending it back creates a weak spot that will eventually fracture. If it was inland, it would not be a big deal. For offshore, I prefer to replace it with a brand new mast to avoid an unexpected break. Some day, I will figure out how to heat treat the bent masts so that they are less susceptible to fractures.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

07-26-2020, 05:25 PM	#1
JohnMckroidJr Senior Member Join Date: May 2014 Location: Fort Lauderdale Posts: 2,036	Try leaving it alone. I have replaced over a dozen bent masts. At one time I would bend them back, but when you bend it back, sometime later you will be peddling along and it will snap. Bending it back creates a weak spot that will eventually fracture. If it was inland, it would not be a big deal. For offshore, I prefer to replace it with a brand new mast to avoid an unexpected break. Some day, I will figure out how to heat treat the bent masts so that they are less susceptible to fractures.