Hobie PA 12 Minn Kota motor build

[Montesdad]

Originally Posted by igotpron

And the nubs on the casette are going to eventually break. When it does replace it with an old shaft from your mirage drive.

Not certain that will happen as I also put a screw and nylon washer on the forward part of the cassette right at the hull line and it's a snug fit - when the motor is pushing forward, the stainless screw is pressing against the hull in a very thick spot. You can see it in the very last picture on the forward part of the cassette.
I wanted a fairly snug fit with a little wiggle room

In addition, I went up to a metal supply shop in Irvine and picked up several 1/2" rods, some stainless tubing and a couple other aluminum. I've seen a couple other setups with one of each.

Appreciate the feedback -

Originally Posted by driftwood

Nice Job! however, I prefer a motor that doesn't take up/eliminate your Mirage drive pedals. I like the idea of using both the pedal and motor at the same time.
By using both the mirage drive pedal power and electric motor simultaneously your battery will last a lot longer and you'll go faster and longer with less strain on your legs.
your project looks good though, let us know how you like it.

Yeah, me too - I guess I could make a mount to use it on the bow, or off the stern - seen some youtube videos of those.
Like I said, was just having some fun - great little project.