I've been trying to figure out how to mount a transducer to my yak. I've looked at mounting through the scupper hole, inside mount and outside mount etc. The best looks to be inside mount using various forms of glues, jellies (vasoline) and epoxies.
My question(s):
- Can someone provide me with step by step instructions (I'm another pain in the ass rookie)
- Does the transducer sit on top of the plastic separated by only the glue or epoxy etc.?
- Reservoir or no reservoir?
- How much of the transducer should be covered with water?
- Drill a hole for the cord? (yep definitely a rookie
)
I've seen so much knowledge passed back and forth via this forum and appreciate your help.
Bret
12-28-2009, 04:55 PM
Threaded Mode