Rip out a flushmount... - Kayak Fishing Adventures on Big Water’s Edge

JrBasser · 08-17-2009, 02:11 PM

..Catch A Yellowtail.

Right under the fish's nose, you can see the hole ha!

I'm using some cheap cutting board now to make a large backing plate that fits up under both flushmounts to add support. I'm going to use some over sized screws that fit over the entire hole, not into the counter sunk part due to damage on the inside plastic and I think it will make the strength of the specified area leagues stronger.with small screws and washers it is already much better and it is only half way on (just bolted up for fitment. I'll post in the general discussion board a few pics when I'm done.

08-17-2009, 02:11 PM	#1
JrBasser Senior Member Join Date: May 2006 Posts: 260	Rip out a flushmount... ..Catch A Yellowtail. Right under the fish's nose, you can see the hole ha! I'm using some cheap cutting board now to make a large backing plate that fits up under both flushmounts to add support. I'm going to use some over sized screws that fit over the entire hole, not into the counter sunk part due to damage on the inside plastic and I think it will make the strength of the specified area leagues stronger.with small screws and washers it is already much better and it is only half way on (just bolted up for fitment. I'll post in the general discussion board a few pics when I'm done.