Plano Box for Prowler 13 - Kayak Fishing Adventures on Big Water’s Edge

prowlerdude · 10-06-2008, 04:39 PM

Here is what I did. I got a diamond mount for the rail and put the FF there and then put a RAM revolution in the middle spot. I also have the "tub" also. I used cut outs from an old ("Honey have you seen the cutting board") cutting board as backing for strength. I run the fishfinder off rechargeable AA batteries and keep them in a small drybag. I mounted the transducer in goop and have had no problem.

Hope this helps

Mike

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

10-06-2008, 04:39 PM	#5
prowlerdude Senior Member Join Date: May 2007 Location: Clairemont Posts: 116	Here is what I did. I got a diamond mount for the rail and put the FF there and then put a RAM revolution in the middle spot. I also have the "tub" also. I used cut outs from an old ("Honey have you seen the cutting board") cutting board as backing for strength. I run the fishfinder off rechargeable AA batteries and keep them in a small drybag. I mounted the transducer in goop and have had no problem. Hope this helps Mike