Kayak Fishing Adventures on Big Water’s Edge - View Single Post

Hunters Pa · 08-22-2018, 02:04 PM

I would have opted for dropping a scrap piece of blank tip through the larger of the two broken pieces so the taper would fit snug against the inside of the broken tip piece as well as the larger piece. This should splint better as it would be in contact with more surface area on both sides of the break as well as still flex some. Could split an inch or so of blank to splint the outside as well and wrap over it.

Then again, may be really hard to do the inside one if all you could fit was 1/16" metal rod.

08-22-2018, 02:04 PM	#11
Hunters Pa Senior Member Join Date: Jul 2006 Location: Fullerton Posts: 1,358	I would have opted for dropping a scrap piece of blank tip through the larger of the two broken pieces so the taper would fit snug against the inside of the broken tip piece as well as the larger piece. This should splint better as it would be in contact with more surface area on both sides of the break as well as still flex some. Could split an inch or so of blank to splint the outside as well and wrap over it. Then again, may be really hard to do the inside one if all you could fit was 1/16" metal rod.