[fongman]

I wanted to increase the dry storage under the center hatch, so I installed a raised floorboard in my Hobie. It extends from the center support to the seat scupper posts. The tray holders mounted on the sides of the hull keep the floorboard from moving laterally.





It is made out of 1/16" polycarbonate and is very light, yet strong. I covered it with a non-slip, rubber drawer liner. The red circle is where I put an emergency knockout, in case it is necessary to pump water out of the hull. A spade drill bit was used to create the knockout. It was then cemented to another piece of polycarbonate and reattached to the floorboard from the bottom side. A dab of goop on each corner holds the plug in place.

To provide support, I split a 3" section of pool noodle lengthwise and gooped the 2 pieces down the centerline of the hull, at each end of the floorboard. This provides support and allows residual water to flow through.