|
Scallywag, I have the Outback, but the hull design near the mast section is essentially the same I imagine....the problem is I don't have that kind of transducer, mine looks like this.....not sure how I would fabricate a device to clamp on to it since it's round like a hockey puck......however I could just lay it down there inside the well and use something to keep it from sliding around....i looks like yours sitting on the hull practically. With the Airmar, I don't think I can get enough water into the hull for it to touch the transducer, there is about an inch or so clearance between the bottom of the well and where the transucer seats.
|