Very Good Point! So I did a Quick & Easy Fix. I took a soft large tapered red scupper plug and drilled a 3/4" hole through the center of it, cut it in half and slid the two pieces up the bottom of the light pole and spaced them out. It seats vey snugly in the center rod holder on my bait tank (I can even lift the hole thing by grabbing the pole)it is not going to slide out if I roll over. It pops right out too with a little tugging. I'm not too worried about losing a rod holder at all since it is a PA & I have more than enough places to put rods. Always Better to be safe than sorry fer sure.